Engine Mounting Bracket

WARNING: This page is about a different variant/trim than selected.

Install the jack to the edge of upper oil pan to support the engine.
NOTE: Insert the rubber block between jack and oil pan.
Disconnect the ground cable (A), and then remove the engine mounting support bracket (B).
Tightening torque

Ground line bolt:

10.8 ~ 13.7 N.m (1.1 ~ 1.4 kgf.m, 8.0 ~ 10.1 lb-ft)

Nut and bolt:

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

Fig 1: Disconnecting Ground Cable
Courtesy of HYUNDAI MOTOR AMERICA

Fig 2: Removing Engine Mounting Support Bracket
Courtesy of HYUNDAI MOTOR AMERICA
Remove the reservoir tank (A).

Fig 3: Removing Reservoir Tank
Courtesy of HYUNDAI MOTOR AMERICA
Remove the engine mounting bracket (A).
Tightening torque:

68.6 ~ 88.3 N.m (7.0 ~ 9.0 kgf.m, 50.6 ~ 65.1 lb-ft)

Fig 4: Removing Engine Mounting Bracket
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.