Repair Procedures: Installation
WARNING: This page is about a different variant/trim than selected.
Install the other parts in reverse order of removal.
Perform the following:
- Refill a radiator and a reservoir tank with engine coolant. (Refer to COOLANT )
- Check the engine oil level. If necessary, refill engine with engine oil.
- Check the transaxle oil level. If necessary, refill a transaxle with fluid.
- Charging the refrigerant gas.
- Adjust a shift cable.
- Adjust the head lamp aiming and front wheel alignment.
- Adjust the front radar.
- Inspect for fuel leakage.