LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Timing System - 2.0L (Except HEV)) >> Drive Belt >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the front tire.

    (Refer to Suspension System - "WHEEL ")

  2. Remove the engine room under cover.

    (Refer to Engine And Transmission Assembly - "ENGINE ROOM UNDER COVER ")

  3. For release the tension, turn the drive belt tensioner counterclockwise then remove the drive belt (A).
    Fig 1: Identifying Drive Belt
    G11993829Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the water pump belt.
    1. Insert the SST (09252-03100) between the water pump pulley and the water pump belt.
    2. Remove the water pump belt (A) by turning the damper pulley clockwise.
      Fig 2: Identifying Water Pump Belt
      G11993830Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals