Removal and Installation

WARNING: This page is about a different variant/trim than selected.

Remove the drive belt.
(Refer to Timing System - "DRIVE BELT ")
Remove the drive belt auto tensioner pulley (A).
Tightening torque:

53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39.8 ~ 47.0 lb-ft)

Fig 1: Removing Drive Belt Auto Tensioner Pulley
Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: Tensioner pulley bolt is left-hands screw.
Remove the drive belt tensioner (A).
Tightening torque:

19.6 ~ 24.5 N.m (2.0 ~ 2.5 kgf.m, 14.5 ~ 18.1 lb-ft)

Fig 2: Identifying Drive Belt Tensioner
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.