Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Turn ignition switch OFF and disconnect the negative (-) battery cable.
Remove the engine cover.
Disconnect the ignition coil connector (A).

Fig 1: Locating Ignition Coil Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the ignition coil (A).

Fig 2: Locating Ignition Coil
Courtesy of HYUNDAI MOTOR AMERICA
NOTE:
- When removing the ignition coil connector, pull the lock pin (A) and push the clip (B).
Fig 3: Pulling Lock Pin
Courtesy of HYUNDAI MOTOR AMERICA