LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 47 (Automatic Transaxle Control System - 2.0L (Except HEV)) >> Shift Lever >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect a boots from the console upper cover.
  2. Pull the knob (A) in the direction of "F" and remove the knob.
    Fig 1: Pulling Knob
    G11994885Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the floor console assembly.

    (Refer to Body - "FLOOR CONSOLE ")

  4. Remove the air duct (A).
    Fig 2: Removing Air Duct
    G11994886Courtesy of HYUNDAI MOTOR AMERICA
  5. Disconnect the connector (A) from the shift lever.
    Fig 3: Disconnecting Connector From Shift Lever
    G11994887Courtesy of HYUNDAI MOTOR AMERICA
  6. Disconnect the control cable (A).
    1. Disconnect the cable holder (A) from the shift lever.
    2. Disconnect the cable bracket from the shift lever after pushing the lock.
    Fig 4: Disconnecting Cable Holder From Shift Lever
    G11994888Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the bolts and then shift lever assembly (A).

    Tightening torque: 

    8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

    Fig 5: Removing Bolts And Shift Lever Assembly
    G11994889Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the P position switch mounting bracket (A).
    Fig 6: Removing P Position Switch Mounting Bracket
    G11994890Courtesy of HYUNDAI MOTOR AMERICA
  9. Disconnect the P position switch (A) and shift lock solenoid (B).
    Fig 7: Disconnecting P Position Switch And Shift Lock Solenoid
    G11994891Courtesy of HYUNDAI MOTOR AMERICA
  10. Disconnect the manual mode switch housing (A).
    Fig 8: Disconnecting Manual Mode Switch Housing
    G11994892Courtesy of HYUNDAI MOTOR AMERICA
  11. Disconnect the main connector (A) from the shift lever.
    Fig 9: Disconnecting Main Connector From Shift Lever
    G11994893Courtesy of HYUNDAI MOTOR AMERICA
  12. P position switch, shift lock solenoid, manual mode switch housing, main connector assembly (A).
    Fig 10: Locating Main Connector Assembly
    G11994894Courtesy of HYUNDAI MOTOR AMERICA
  13. Remove the mounting bracket (A) of terminals from the main connector.
    Fig 11: Removing Mounting Bracket Of Terminals From Main Connector
    G11994895Courtesy of HYUNDAI MOTOR AMERICA
  14. Remove each terminals (F) of the P position switch (A), shift lock solenoid (B), manual mode switch housing (C) after released lock (E) from the main connector (D).
CAUTION:
  • Record the location of the wiring colors before disconnecting the terminals.
Fig 12: Wiring Colors Location
G11994896Courtesy of HYUNDAI MOTOR AMERICA
Fig 13: Locating P Position Switch, Shift Lock Solenoid, Manual Mode Switch Housing And Main Connector
G11994897Courtesy of HYUNDAI MOTOR AMERICA
NOTE:
  • Connector information
Fig 14: Shift Lever Connector Terminals
G11994898Courtesy of HYUNDAI MOTOR AMERICA
  1. 3. Shift lock solenoid (+)
  2. 4. Shift lock solenoid (-)
  3. 5. Sport mode switch signal (-)
  4. 6. Sports mode down switch
  5. 7. Sports mode select switch
  6. 8. Sports mode up switch
  7. 9. P (Parking) position switch (-)
  8. 10. P (Parking) position switch (+)
scientia non olet · About LEMON Manuals