LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 47 (Automatic Transaxle Control System - 2.0L (Except HEV)) >> Shift Cable >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Air cleaner assembly and air duct.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  2. Battery and battery tray.

    (Refer to Engine Electrical System - "BATTERY ")

  3. Remove the nut (A) from the manual control lever.
  4. Remove the shift cable (B) from the bracket (C) at transaxle side.
    Fig 1: Removing Nut From Manual Control Lever And Shift Cable From Bracket
    G11994900Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the floor console assembly.

    (Refer to Body - "FLOOR CONSOLE ")

  6. Remove the air duct (A).
    Fig 2: Removing Air Duct
    G11994901Courtesy of HYUNDAI MOTOR AMERICA
  7. Disconnect the shift cable (A).
    1. Disconnect the cable bracket from the shift lever after pushing the lock.
    2. Disconnect the cable holder (A) from the shift lever.
    Fig 3: Disconnecting Cable Holder From Shift Lever
    G11994902Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the airbag module.

    (Refer to Restraint - Airbag Module - "AIRBAG MODULES & CLOCK SPRING - SONATA (EXCEPT HEV) ")

  9. Disconnect the shift cable retainer (B) after removing the mounting nut (A).
  10. Remove the shift cable by pulling it toward the interior.
Fig 4: Disconnecting Shift Cable Retainer Mounting Nut
G11994903Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals