DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible cause |
| DTC Strategy |
- Monitoring deviation between target idle speed and actual engine speed during catalyst heating.
|
- Restriction in intake or exhaust system
- Air leakage
- Checking operation of ETC
|
| Enable Conditions |
- Coolant temperature is between -10°C (14°F) and 30°C (86° F)
- Time after start is longer than 5 sec
- Vehicle speed is slower than 3 km/h (1.9 mph)
- Pedal value is less than 0.01%
|
| Threshold value |
- Current RPM is lower than target RPM as much as 270 RPM (Engine speed too low) or Current RPM is higher than target RPM as much as 200 RPM (Engine speed too high)
|
| Diagnosis Time |
|
| MIL On Condition |
|