DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible cause |
| DTC Strategy |
- Check fuel tank under pressure during evacuation
|
- Fuel Filler Cap missing
- Leakage in each hose/fuel filler pipe
- Leakage in CCV/Canister/Fuel tank
- Stuck in each purge hose/pipe between fuel tank and intake manifold
|
| Enable Conditions |
- Coolant temperature is higher than 50°C (122°F)
- Ambient Air Temperature (AAT) is higher than -10°C (14°F)
- Vehicle speed is slower than 12 km/h (7.5 mph)
- Fuel level is less than 85%
- Time after engine starts has passed 100 second.
- Ambient pressure is greater than 75 kPa
|
| Case 1 |
Threshold value |
- Time to generate under pressure (is less than -15 hPa) is greater than 20 sec. (too long)
|
| Diagnosis Time |
- 25 sec. in Idle when all Enable Conditions fulfilled
|
| Case 2 |
Threshold value |
- Time for DTP to decrease from -300 Pa (-3 hPa) to -700 Pa (-7 hPa) during Evacuation is greater than 10 sec.
|
| Diagnosis Time |
- 15 sec. in Idle when all Enable Conditions fulfilled
|
| MIL On Condition |
|