DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible cause |
| DTC Strategy |
|
- Poor connection or damaged harness
- Boost Pressure Sensor (PUT)
|
| Enable Conditions |
- Engine off time is longer than 4 sec
- PUT sensor voltage is higher than 0.16 V and lower than 4.92 V
- 0.15 V to less than MAP sensor voltage is higher than 0.15 V and lower than 4.85 V
|
| Threshold Value |
- 3 preconditions under the engine stop
- Difference between PUT (pressure upstream throttle) pressure and MAP (manifold air pressure) is higher than 10 KPa
- Difference between PUT (pressure upstream throttle) pressure and AMP (atmosphere pressure) is higher than 10 KPa
- Difference between AMP (atmosphere pressure) and MAP (manifold air pressure) is lower than 10 KPa
|
| Diagnostic Time |
|
| Mil On Condition |
|