LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 41 (Engine Cooling System - 2.0L (Except HEV)) >> Cooling Fan >> Repair Procedures >> Removal and Installation >> Resistor

Removal and Installation: Resistor

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the wire harness connector (A) and fan motor connector (B).
    Fig 1: Disconnecting Wire Harness Connector And Fan Motor Connector
    G11994024Courtesy of HYUNDAI MOTOR AMERICA
  2. Remove the resistor (A) from fan shroud.

    Tightening torque: 

    1.7 ~ 2.4 N.m (0.18 ~ 0.25 kgf.m, 1.3 ~ 1.8 lb-ft)

    Fig 2: Removing Resistor From Fan Shroud
    G11994025Courtesy of HYUNDAI MOTOR AMERICA
  3. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals