Cooling Fan Assembly

WARNING: This page is about a different variant/trim than selected.

Disconnect the battery terminals.
Remove the air cleaner assembly.
(Refer to Intake And Exhaust System - "AIR CLEANER ")
Remove the under cover.
(Refer to Engine And Transaxle Assembly - "ENGINE ROOM UNDER COVER ")
Loosen the drain plug, and drain the coolant.
(Refer to Cooling System - "COOLANT ")
Remove the front bumper cover.
(Refer to Body - "FRONT BUMPER COVER ")
Disconnect the wire harness connector (A).

Fig 1: Disconnecting Wire Harness Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the air intake shield (A).

Fig 2: Removing Air Intake Shield
Courtesy of HYUNDAI MOTOR AMERICA
Remove the radiator upper hose (A).

Fig 3: Removing Radiator Upper Hose
Courtesy of HYUNDAI MOTOR AMERICA
Remove the radiator lower hose bolt (A).

Fig 4: Removing Radiator Lower Hose Bolt
Courtesy of HYUNDAI MOTOR AMERICA
Remove the radiator over flow hose (A) and upper bracket (B).

Fig 5: Removing Radiator Over Flow Hose And Upper Bracket (1 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA

Fig 6: Removing Radiator Over Flow Hose And Upper Bracket (2 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the cooling fan (A) from radiator.

Fig 7: Disconnecting Cooling Fan From Radiator
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.