Repair Procedures: Disassembly

WARNING: This page is about a different variant/trim than selected.

Remove the cooling fan (A) from cooling fan assembly.
Tightening torque:

2.7 ~ 3.2 N.m (0.28 ~ 0.33 kgf.m, 2.0 ~ 2.3 lb-ft)

Fig 1: Removing Cooling Fan From Cooling Fan Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Remove the fan motor connector (A) from resistor.

Fig 2: Removing Fan Motor Connector From Resistor
Courtesy of HYUNDAI MOTOR AMERICA
Remove the fan motor (A) from cooling fan shroud.
Tightening torque:

3.9 ~ 5.8 N.m (0.4 ~ 0.6 kgf.m, 2.8 ~ 4.3 lb-ft)

Fig 3: Removing Fan Motor From Cooling Fan Shroud
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.