Ground Circuit Inspection
WARNING: This page is about a different variant/trim than selected.
- IG KEY "OFF".
- Disconnect the FTPS connectors.
- IG KEY "ON" & ENG "OFF"
- Measure the voltage between power terminal of FTPS harness connector and chassis ground.(Measurement "A")
- Measure the voltage between power and ground terminals of FTPS harness connector.(Measurement "B")
Specification: Voltage difference between measurement "A" and "B" is below 200mV.
- Is the measured voltage within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.