Ground Circuit Inspection
WARNING: This page is about a different variant/trim than selected.
- IG "OFF".
- Disconnect CMPS connector.
- IG "ON" & ENG "OFF".
- Measure voltage between power terminal of CMPS harness connector and chassis ground.(A)
- Measure voltage between power and ground terminals of CMPS harness connector. (Measurement "B")
Specification: Voltage difference between measurement "A" and "B" is below 200mV
The image file (SVG, SWF, GIF) doesn't exist./data/Passenger/HY/HMA/ENG/ETM-Images/HY-LF33-IMAGES-ENG/
- Is the measured voltage within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.