Component Inspection
WARNING: This page is about a different variant/trim than selected.
- IG "OFF". Connect a GDS and oscilloscope.
- Connect CH A, B probe to (+),(-) control terminal of EWGA connector.
- Warm up the engine to normal operating temperature.
- Measure signal waveform of EWGA control together by actuating the throttle.
Specification: Signal waveform will be displayed as follows.
- Is the measured voltage within specification?
YES
- Substitute with a known - good ECM and check for proper operation. If the problem is corrected, replace ECM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known - good EWGA and check for proper operation. If the problem is corrected, replace EWGA and go to "VERIFICATION OF VEHICLE REPAIR " procedure.