Ground Circuit Inspection
WARNING: This page is about a different variant/trim than selected.
- IG "OFF".
- Disconnect ETC Motor & TPS connector.
- IG "ON" & ENG "OFF".
- Measure voltage between TPS power terminal of ETC Motor & TPS harness connector and chassis ground.(Measurement "A")
- Measure voltage between TPS power and TPS1 ground terminals of ETC Motor & TPS harness connector.(Measurement "B")
Specification: Voltage difference between measurement "A" and "B" is below 200mV.
- Is the measured voltage within specification?
YES
- Go to "COMPONENT INSPECTION " procedure
NO
- Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.