Signal Circuit Inspection
WARNING: This page is about a different variant/trim than selected.
- IG "OFF" and disconnect ETC Motor & TPS connector and ECM connector.
- Measure resistance between TPS 2 signal terminal of ETC Motor & TPS harness connector and chassis ground. (Measurement "A")
- Measure resistance between TPS 2 signal and ground terminals of ETC Motor & TPS harness connector.(Measurement "B")
Specification: Infinite
- Is the measured resistance within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.