LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 38 (Engine Control System Diagnosis - 1.6L (3 Of 3) (Except HEV)) >> DTC U0109: Lost Communication With Fuel Pump Control Module >> Wiring Inspection >> CAN communication circuit inspection

CAN communication circuit inspection

WARNING: This page is about a different variant/trim than selected.
  1. IG "OFF" and disconnect FPCM connector and ECM connector.
  2. Check resistance between CAN-HIGH terminal of FPCM Connector and CAN-HIGH terminal of harness connector. (Measurement "A")
  3. Check resistance between CAN-LOW terminal of FPCM Connector and CAN-LOW terminal of harness connector. (Measurement "B")

    Specification:  Below 1.0 Ω

  4. Is the measured voltage within specification?

    YES 

    • Substitute with a known-good FPCM and check for proper operation. If the problem is corrected, replace FPCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals