LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 38 (Engine Control System Diagnosis - 1.6L (3 Of 3) (Except HEV)) >> DTC P259F: Turbocharger 'A' Boost Control Position At High Limit >> Component Inspection

Component Inspection

WARNING: This page is about a different variant/trim than selected.
  1. IG "OFF". Connect a GDS and oscilloscope.
  2. Connect CH A, B probe to (+),(-) control terminal of EWGA connector.
  3. Warm up the engine to normal operating temperature.
  4. Measure signal waveform of EWGA control together by actuating the throttle.

    Specification:  Signal waveform will be displayed as follows.

  5. Is the measured resistance within specification?

    YES 

    • Substitute with a known - good ECM and check for proper operation. If the problem is corrected, replace ECM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Substitute with a known - good EWGA and check for proper operation. If the problem is corrected, replace EWGA and go to "VERIFICATION OF VEHICLE REPAIR " procedure.