Boost Control Position Sensor Circuit Inspection
WARNING: This page is about a different variant/trim than selected.
- IG "OFF" & Disconnect EWGA connector.
- IG "ON" & ENG "OFF".
- Measure the voltage between signal, ground, power terminal of EWGA (Boost Control Position Sensor) harness connector and chassis ground.
Specification:
Signal Terminal: Approx. 0V
Ground Terminal: Approx. 0V
Power Terminal: Approx. 5V
- Is the measured voltage within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.