Component Inspection
WARNING: This page is about a different variant/trim than selected.
- IG "OFF".
- Disconnect fuel pump.
- Check for motor operating state by connecting battery power to fuel pump control (+) terminal and ground to fuel pump control (-) terminal. (Component side)
- Is the measured normal?
YES
- Substitute with a known - good fuel filter and check for proper operation. If the problem is corrected, replace fuel filter and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- If problem is not fixed with replacing fuel filter, substitute with a known - good FPCM and check for proper operation. If the problem is corrected, replace FPCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known - good fuel pump and check for proper operation. If the problem is corrected, replace fuel pump and go to "VERIFICATION OF VEHICLE REPAIR " procedure.