Fuel pressure sensor power Circuit Inspection
WARNING: This page is about a different variant/trim than selected.
- IG "OFF". Disconnect fuel pressure sensor connector.
- IG "ON".
- Measure the voltage between power terminal of fuel pressure sensor harness connector and chassis ground.
Specification: Above. 5 V
- Is the measured resistance within specification?
YES
- Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.