Repair Procedures: Removal

1. Disconnect a boots from the console upper cover.
2. Pull the knob (A) in the direction of "F" and remove the knob.
   Fig 1: Pulling Knob

   Courtesy of HYUNDAI MOTOR AMERICA
3. Remove the floor console assembly.

   (Refer to Body - "FLOOR CONSOLE ")

4. Disconnect the connector (A) from the shift lever.
   Fig 2: Locating Shift Lever Connector

   Courtesy of HYUNDAI MOTOR AMERICA
5. Disconnect the control cable (A).
   1. Disconnect the cable holder (A) from the shift lever.
   2. Disconnect the cable bracket from the shift lever after pushing the lock.
   Fig 3: Disconnecting Cable Holder From Shift Lever

   Courtesy of HYUNDAI MOTOR AMERICA
6. Remove the bolts and then shift lever assembly (A).

   Tightening torque: 

   8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 Ib-ft)

   Fig 4: Locating Shift Lever Assembly With Bolts

   Courtesy of HYUNDAI MOTOR AMERICA
7. Remove the P position switch mounting bracket (A).
   Fig 5: Locating P Position Switch Mounting Bracket

   Courtesy of HYUNDAI MOTOR AMERICA
8. Disconnect the P position switch (A) and shift lock solenoid (B).
   Fig 6: Locating P Position Switch And Shift Lock Solenoid

   Courtesy of HYUNDAI MOTOR AMERICA
9. Disconnect the main connector (A) from the shift lever.
   Fig 7: Locating Main Connector Of Shift Lever

   Courtesy of HYUNDAI MOTOR AMERICA
10. Remove the mounting bracket (A) of terminals from the main connector.
    Fig 8: Locating Mounting Bracket Of Terminals

    Courtesy of HYUNDAI MOTOR AMERICA
11. Remove each terminals of the P position switch (A), shift lock solenoid (B) from the main connector (C).
    CAUTION: Record the location of the wiring colors before disconnecting the terminals.
    Fig 9: Removing Each Terminals Of P Position Switch And Shift Lock Solenoid From Main Connector

    Courtesy of HYUNDAI MOTOR AMERICA
    Fig 10: Locating P Position Switch, Shift Lock Solenoid And Main Connector

    Courtesy of HYUNDAI MOTOR AMERICA

Information 

• Connector information 

Fig 11: Shift Lever Connector Terminals

Courtesy of HYUNDAI MOTOR AMERICA

1. 3. Shift lock solenoid (-)
2. 4. Shift lock solenoid (+)
3. 5. DCT sensor_IG1
4. 6. CAN (High)
5. 7. CAN (Low)
6. 8. DCT sensor_ground
7. 9. P (Parking) Position switch (-)
8. 10. P (Parking) Position switch (+)