LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 37 (Dual Clutch Transmission Control System - 1.6L (Except HEV)) >> Shift Cable >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the air cleaner assembly and air duct.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  2. Remove the TCM.

    (Refer to Dual Clutch Transmission Control System - "TCM ")

  3. Remove the battery and tray.

    (Refer to Engine Electrical System - "BATTERY ")

  4. Remove the nut (A) from the manual control lever.
  5. Disconnect the shift cable (B) from the bracket (C) at transaxle side.
    Fig 1: Locating Shift Cable, Bracket And Nut
    G11987554Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the floor console assembly.

    (Refer to Body - "FLOOR CONSOLE ")

  7. Disconnect the shift cable (A).
    1. Disconnect the cable bracket from the shift lever after pushing the lock.
    2. Disconnect the cable holder (A) from the shift lever.
    Fig 2: Disconnecting Cable Holder From Shift Lever
    G11987555Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the airbag module.

    (Refer to Restraint - "AIRBAG MODULE DISPOSAL ")

  9. Disconnect the shift cable retainer (B) after removing the mounting nut (A).
  10. Remove the shift cable by pulling it toward the interior.
    Fig 3: Locating Shift Cable Retainer And Mounting Nut
    G11987556Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals