Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.

Install the shift cable retainer (A).
Tightening torque:

9.8 ~ 14.7 N.m (1.0 ~1.5 kgf.m, 7.2 ~ 10.8 Ib-ft)

Fig 1: Locating Shift Cable Retainer
Courtesy of HYUNDAI MOTOR AMERICA
Install the shift cable (A) in the shifter lever.
NOTE:
- Install the cable after placing the shift lever and the manual control lever in the N position.
  
  Fig 2: Installing Shift Cable In Shifter Lever
  Courtesy of HYUNDAI MOTOR AMERICA
Align the hole (A) in the manual control lever with the "N" position hole (B) of the inhibitor switch and then insert the inhibitor switch guide pin (SST No.: 09480-A3800).

Fig 3: Inserting Inhibitor Switch Guide Pin (SST No.:09480-A3800)
Courtesy of HYUNDAI MOTOR AMERICA
Install the shift cable (B) in the cable bracket (C).
Lightly tighten the nut (A) after connected the shift cable (B) in the manual control lever (D).
Push shift cable (B) lightly to "F" direction shown to eliminate free play of shift cable.
Tighten the nut (A) to the specified torque.

Fig 4: Pushing Shift Cable
Courtesy of HYUNDAI MOTOR AMERICA
Install the airbag module.
(Refer to Restraint - "AIRBAG MODULE DISPOSAL ")
Install the floor console assembly.
(Refer to Body - "FLOOR CONSOLE ")
Install the battery and battery tray.
(Refer to Engine Electrical System - "BATTERY ")
Install the TCM.
(Refer to Dual Clutch Transmission Control System - "TCM ")
Install the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "AIR CLEANER ")
CAUTION:
- Check that operating surely at each range of the inhibitor switch corresponding to each position of shift lever.