LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 37 (Dual Clutch Transmission Control System - 1.6L (Except HEV)) >> Inhibitor Switch >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Make sure vehicle does not roll before setting shift lever to "N" position.
  2. Remove the air cleaner assembly and air duct.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  3. Remove the battery and tray.

    (Refer to Engine Electrical System - "BATTERY ")

  4. Disconnect the inhibitor switch connector (A)
  5. Remove the shift cable mounting nut (B).
    Fig 1: Locating Inhibitor Switch Connector And Shift Cable Mounting Nut
    G11987529Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the manual control lever (B) and the washer after removing a nut (A).
    Fig 2: Locating Manual Control Lever And Nut
    G11987530Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the inhibitor assembly (A) after removing the bolts.
    Fig 3: Locating Inhibitor Assembly Bolts
    G11987531Courtesy of HYUNDAI MOTOR AMERICA
    Fig 4: Locating Inhibitor Switch
    G11987532Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals