DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
|
- Poor connection
- Leak or clog in intake air system
- Injector
- Fuel pressure
- S1
|
| Enable Conditions |
- Sensor Ceramic Temp. is higher than 720°C (1, 328°F)
- ECT is higher than 40.5°C (104.9°F)
- Purge active time is higher then 5sec
- Engine load is higher than 20% and lower than 60%.
- Exhaust Gas temperature is higher than 400°C (752°F).
- Fuel cut condition OFF
- Closed loop fuel control
- Engine speed is higher than 1320 RPM and lower than 3000 RPM.
|
| Threshold Value |
- Ratio of expected area to actual area is lower than 0.2.
|
| Diagnostic Time |
|
| MIL ON Condition |
|