Ground Circuit Inspection

WARNING: This page is about a different variant/trim than selected.

IG "OFF".
Disconnect ECTS connector.
IG "ON" & ENG "OFF".
Measure the voltage between signal terminal of ECTS harness connector and chassis ground.(A)
Measure the voltage between signal and ground terminal of ECTS harness connector and chassis ground.(B)
Specification: Voltage difference between measurement "A" and "B" is below 200mV.
Is the measured resistance within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.