DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
- Coolant temp not reached warm up state
|
- Thermostat open stuck
- Poor connection or damaged harness
|
| Enable Conditions |
- Fuel-cut off phase is less than 20%
- Low load phase is less than 50%
- Battery voltage between 11 V and 16 V
- Intake air temperature decrease compared to Start Intake air temperature is greater than -10°C (-14°F)
- Coolant temperature at start between -10°C (14°F) and 54.4°C (131°F)
|
| Threshold Value |
- Measured coolant temp. is less than 74°C (165°F) When modeled coolant temp. is greater than 85°C (185°F)
|
| Diagnosis Time |
- 10~30 min. depending on coolant temperature at start and driving pattern
|
| Mil On Condition |
|