Component Inspection

WARNING: This page is about a different variant/trim than selected.

■ ECTS Inspection

Measure the resistance between signal terminal and ground terminal of ECTS connector. (Component side)

Specification:

Temp.(°C)	Temp.(°F)	Resistance (kΩ)	Temp.(°C)	Temp.(°F)	Resistance (kΩ)
-40	-40	48.14	20	68	1.15
-20	-4	14.13 ~ 16.83	40	104	0.59
0	32	5.79	60	140	0.32
10	50	2.31 ~ 2.59

Is the measured resistance within specification?
YES
- Clear DTC and Test-drive under the enable conditions. After the road test, if this DTC is set, recheck resistance. If not, it is intermittent fault. Go to "VERIFICATION OF VEHICLE REPAIR ",
NO
- Check ECTS for contamination, deterioration, or damage. Substitute with a known-good ECTS and check for proper operation. If the problem is corrected, replace ECTS and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.