DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
|
- Poor connection or damaged harness
- Faulty IAT sensor
|
| Case 1 |
Enable Conditions |
- Engine speed during engine start higher than 640 to 960 RPM
- Battery voltage is between 6 V and 16 V
- Engine Coolant Temperature (ECT) higher than 74°C (165.2°F)
- Integrated mass air flow greater 10000
- Engine stop time longer than 10 sec.
|
| Threshold Value |
- Intake air temperature signal variation since Engine Start lower than 1.5°C (34.7°F)
|
| Diagnosis Time |
|
| Case 2 |
Enable Conditions |
- Battery voltage is between 6 V and 16 V
|
| Threshold Value |
- Noisy signal: The difference between IAT and IAT moving mean value higher than 8.5°C (47.3°F) within 0.5 sec.
|
| Diagnosis Time |
|
| Case 3 |
Enable Conditions |
- Battery voltage is between 6 V and 16 V
- Engine stop time longer than 480 min
- Engine Coolant Temperature (ECT) drop is lower than 2°C (35.6°F) within 15 sec. right after engine starts
|
| Threshold Value |
- Deviation between IAT and 2 other temp sensors (ECT, AAT or EOT) and Deviation among other temp sensors (ECT, AAT, EOT) higher than 20°C (68°F) or lower than 20 °C (68°F)
|
| Diagnosis Time |
|
| MIL On Condition |
|