LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 32 (Engine Control System Diagnosis - 2.0L (1 Of 3) (Except HEV)) >> DTC P0011: 'A' Camshaft Position-Timing Over-Advanced or System Performance (Bank 1) >> DTC Information >> DTC Detecting Condition

DTC Information: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.
Item Detecting Condition Possible Cause
Case 1 DTC Strategy
  • Deviation check between actual CAM position and CAM set point position in case of changing set point (slow response of actuator)
 1. CVVT Assembly
Enable Conditions
  • Camshaft setpoint moving by more than 12°CRK within less than 0.8 sec.
  • Camshaft setpoint moved more than 3 times since engine start
  • Battery voltage is between 11 V and 16 V
  • Engine speed (RPM) is between 600 to 1500 and 5000 RPM
  • Engine oil temp. is between 20°C (68°F) and 120°C (248°F)
Threshold Value
  • CAM position movement is less than 3.4 °CRK within 0.8 sec. (with CAM setpoint moving by 12 °CRK)
Case 2 DTC Strategy
  • Deviation check between actual CAM position and CAM setpoint position (steady deviation)
Enable Conditions
  • Camshaft setpoint moved more than 3 times since engine start
  • Camshaft setpoint not close to full retard position
  • Battery voltage is between 11 V and 16 V
  • Engine speed (RPM) is between 600 to 1500 and 5000 RPM
  • Engine oil temp. is between 20°C (68°F) and 120°C (248°F)
Threshold Value
  • The absolute value of difference between Camshaft position actual value and Camshaft position setpoint is greater than 45°CRK/sec.
Diagnosis Time
  • Immediate
MIL On Condition
  • 2 Driving Cycles
scientia non olet · About LEMON Manuals