Transaxle Mounting Bracket

WARNING: This page is about a different variant/trim than selected.

Remove the air cleaner assembly.
(Refer to Intake and Exhaust System - "AIR CLEANER ")
Remove the battery and tray.
(Refer to Engine Electrical System - "BATTERY ")
Remove the ECM.
(Refer to Fuel System - "ENGINE CONTROL MODULE ")
Remove the engine room under cover.
(Refer to Engine Room Under Cover - "ENGINE ROOM UNDER COVER ")
Install the jack to the edge of transaxle.
Remove the service cover (A).

Fig 1: Locating Service Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the transaxle mounting bolts (A).
Tightening torque :

107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft)

Fig 2: Locating Transaxle Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the transaxle mounting bracket (A).
Tightening torque :

68.6 ~ 88.3 N.m (7.0 ~ 9.0 kgf.m, 50.6 ~ 65.1 lb-ft)

Fig 3: Locating Transaxle Mounting Bracket With Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.