Engine Mounting Support Bracket

WARNING: This page is about a different variant/trim than selected.

Remove the engine room under cover.
Remove the reservoir tank. (Refer to Cooling System - "Reservoir Tank")
Install the jack to the edge of upper oil pan to support the engine.
NOTE: Insert the rubber block between jack and oil pan.
Remove the engine mounting support bracket (A).
Tightening torque :

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

Fig 1: Locating Engine Mounting Support Bracket With Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
Remove the engine mounting bracket (A).
Tightening torque :

68.6 ~ 88.3 N.m (7.0 ~ 9.0 kgf.m, 50.6 ~ 65.1 lb-ft)

Fig 2: Locating Engine Mounting Bracket With Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA