LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 29 (Engine Control System - 2.0L (Except HEV)) >> Rail Pressure Sensor (RPS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Release the residual pressure in fuel line (Refer to "RELEASE RESIDUAL PRESSURE IN FUEL LINE " in this procedure).
    CAUTION: When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of "Release Residual Pressure in Fuel Line" work.
  3. Remove the intake manifold (Refer to "INTAKE & EXHAUST SYSTEM " in EM procedure).
  4. Remove the delivery pipe foam (A).
    Fig 1: Removing Delivery Pipe Foam
    G11994389Courtesy of HYUNDAI MOTOR AMERICA
  5. Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe.
Fig 2: Disconnecting Rail Pressure Sensor Connector
G11994390Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals