LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 29 (Engine Control System - 2.0L (Except HEV)) >> Manifold Absolute Pressure Sensor (MAPS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the manifold absolute pressure sensor connector (A).
  3. Remove the installation bolt (B), and then remove the sensor from the surge tank.

    [MAPS #1] 

    Fig 1: Disconnecting Manifold Absolute Pressure Sensor Connector (MAPS 1)
    G11994352Courtesy of HYUNDAI MOTOR AMERICA

    [MAPS #2] 

    Fig 2: Disconnecting Manifold Absolute Pressure Sensor Connector (MAPS 2)
    G11994353Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals