LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 29 (Engine Control System - 2.0L (Except HEV)) >> ETC (Electronic Throttle Control) System >> Repair Procedures >> Inspection >> Throttle Position Sensor (TPS)

Throttle Position Sensor (TPS)

WARNING: This page is about a different variant/trim than selected.
  1. Connect the GDS on the Data Link Connector (DLC).
  2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.

    Specification:  Refer to "SPECIFICATION "

  3. Turn the ignition switch OFF and disconnect the scantool from the DLC.
  4. Disconnect the ETC module connector and measure the resistance between the ETC module terminals 1 and 2.

    Specification:  Refer to "SPECIFICATION "