LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 29 (Engine Control System - 2.0L (Except HEV)) >> Crankshaft Position Sensor (CKPS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the crankshaft position sensor connector (A).
    Fig 1: Disconnecting Crankshaft Position Sensor Connector
    G11994367Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the protector (A).
    Fig 2: Removing Protector
    G11994368Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the installation bolt (A), and then remove the crankshaft position sensor.
Fig 3: Removing Crankshaft Position Sensor Installation Bolt
G11994369Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals