LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 29 (Engine Control System - 2.0L (Except HEV)) >> Canister Close Valve (CCV) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Lift the vehicle.
  3. Remove the rear-left wheel & tire and the wheel house cover.
  4. Disconnect the canister close valve connector (A).
  5. Disconnect the ventilation hose (B) connected to the fuel tank air filter and canister close valve.
  6. Remove the fuel tank air filter after removing the installation bolt (C).
    Fig 1: Disconnecting Canister Close Valve Connector
    G11994440Courtesy of HYUNDAI MOTOR AMERICA
  7. Release the lever (A), and then rotate the canister close valve (B) in the direction of an arrow.
  8. Remove the canister close valve from the fuel tank air filter.
Fig 2: Releasing Lever
G11994441Courtesy of HYUNDAI MOTOR AMERICA
Fig 3: Rotating Canister Close Valve
G11994442Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals