LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 29 (Engine Control System - 2.0L (Except HEV)) >> Camshaft Position Sensor (CMPS) >> Repair Procedures >> Removal >> [Bank 1/Intake]

[Bank 1/Intake]

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the camshaft position sensor connector (A).
  3. Remove the installation bolt (B), and then remove the sensor.
Fig 1: Disconnecting Camshaft Position Sensor Connector (Bank 1/Intake)
G11994373Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals