Removal and Installation

WARNING: This page is about a different variant/trim than selected.

Remove the front muffler (A).
Tightening torque:

39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 Ib-ft)

Fig 1: Locating Front Muffler
Courtesy of HYUNDAI MOTOR AMERICA
Remove the floor under cover (A), and then remove the stay bracket (B).

Fig 2: Locating Floor Under Cover And Stay Bracket
Courtesy of HYUNDAI MOTOR AMERICA
Remove the center muffler (A).
Tightening torque:

39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)

Fig 3: Locating Center Muffler
Courtesy of HYUNDAI MOTOR AMERICA
Remove the main muffler (A).
Tightening torque:

39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)

Fig 4: Locating Main Muffler
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
NOTE: When installing, replace with new gaskets.