LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (Fuel Delivery System - 2.0L (Except HEV)) >> Fuel Tank >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Release the residual pressure in fuel line.

    (Refer to the Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")

  2. Remove the rear seat cushion.

    (Refer to Body - "REAR SEAT ASSEMBLY ")

  3. Remove the fuel pump service cover (A) in the trunk.
    Fig 1: Removing Fuel Pump Service Cover In Trunk
    G11994601Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the fuel feed tube quick-connector (A).
  5. Disconnect the fuel pressure sensor connector (B).
  6. Disconnect the fuel pump control module (C).
    Fig 2: Disconnecting Fuel Feed Tube Quick-Connector And Electrical Connectors
    G11994602Courtesy of HYUNDAI MOTOR AMERICA
  7. Lift the vehicle.
  8. Remove the main muffler.

    (Refer to Engine Mechanical System - "MUFFLER ")

  9. Support the fuel tank with a jack.
  10. Disconnect the fuel filler hose (A).
  11. Disconnect the vapor hose quick-connector (A).
    Fig 3: Disconnecting Vapor Hose Quick-Connector
    G11994603Courtesy of HYUNDAI MOTOR AMERICA
  12. Disconnect the fuel tank pressure sensor extension connector (A).
    Fig 4: Disconnecting Fuel Tank Pressure Sensor Extension Connector
    G11994604Courtesy of HYUNDAI MOTOR AMERICA
  13. Remove the fuel tank bands (A) installation nuts.
    Fig 5: Removing Fuel Tank Bands Installation Nuts
    G11994605Courtesy of HYUNDAI MOTOR AMERICA
  14. Remove the fuel tank after removing the fuel tank band (A) as shown in Fig 6.
Fig 6: Removing Fuel Tank Band
G11994606Courtesy of HYUNDAI MOTOR AMERICA