LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (Fuel Delivery System - 2.0L (Except HEV)) >> Fuel Pump >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Release the residual pressure in fuel line.

    (Refer to the Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")

  2. Lift the vehicle.
  3. Support the fuel tank with a jack.
  4. Pull fuel tank in down direction by loosening the mounting nut (A) appropriately.
    Fig 1: Fuel Tank Mounting Nuts
    G11994608Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the rear seat cushion.

    (Refer to Body - "REAR SEAT ASSEMBLY ")

  6. Remove the fuel pump service cover (A).
    Fig 2: Removing Fuel Pump Service Cover
    G11994609Courtesy of HYUNDAI MOTOR AMERICA
  7. Disconnect the fuel pump control module connector (A).
  8. Disconnect the fuel feed tube quick-connector (B).
  9. Disconnect the fuel pressure sensor connector (C).
    Fig 3: Disconnecting Fuel Feed Tube Quick-Connector And Electrical Connectors
    G11994610Courtesy of HYUNDAI MOTOR AMERICA
  10. Remove the locking ring (A) by using the special service tool (B) [No.: 09310-B9100].
    Fig 4: Removing Locking Ring
    G11994611Courtesy of HYUNDAI MOTOR AMERICA
  11. Remove the fuel pump from the fuel tank.
Fig 5: Removing Fuel Pump From Fuel Tank
G11994612Courtesy of HYUNDAI MOTOR AMERICA