Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Remove the fuel pump.
(Refer to Fuel Delivery System - "FUEL PUMP ")
Disconnect the electric pump wiring connector (A), and the fuel sender connector (B).

Fig 1: Disconnecting Electric Pump Wiring Connector And Fuel Sender Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the reservoir-cup after releasing the fixing hook (A).

Fig 2: Removing Reservoir-Cup Fixing Hook
Courtesy of HYUNDAI MOTOR AMERICA
Remove the fixing clip (A), and then disconnect the fuel tube (B).

Fig 3: Disconnecting Fuel Tube
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the ground cable (A).
Remove the head assembly (B) after removing the cushion pipe fixing clip (C).

Fig 4: Disconnecting Ground Cable
Courtesy of HYUNDAI MOTOR AMERICA
Remove the pre-filter (B) after releasing the fixing hooks (A).

Fig 5: Removing Pre-Filter Fixing Hooks
Courtesy of HYUNDAI MOTOR AMERICA
Remove the fuel pump motor (A) in the direction of an arrow.

Fig 6: Removing Fuel Pump Motor

Courtesy of HYUNDAI MOTOR AMERICA

Fig 7: Locating Fuel Pump Motor

Courtesy of HYUNDAI MOTOR AMERICA