Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

WARNING: Whenever the high pressure fuel pump, fuel pipe, delivery pipe, or injector is removed immediately after shutting off the engine, an injury may be caused by the release of highly pressurized fuel. Release the residual pressure in the high pressure fuel line by referring to the "Residual fuel pressure release procedure" before removing any high pressure fuel system components.

Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")
Turn the ignition switch OFF, and then remove battery (-) cable.
Disconnect the fuel feed tube quick-connector (A).

Fig 1: Disconnecting Fuel Feed Tube Quick-Connector
Courtesy of HYUNDAI MOTOR AMERICA

NOTE: Open the clamp cover (B) before disconnect the quick connector. (If the clip is applied)

Fig 2: Opening Clamp Cover
Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: When removing the quick-connector with the clip removing tool (A), be careful not to damage the plastic clip (B). If the clip is damaged, fuel line leak can be occurred due to a bad connection.

Fig 3: Removing Quick-Connector With Clip Removing Tool
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the vapor hose (A) which is connected from the PCSV.

Fig 4: Disconnecting Vapor Hose
Courtesy of HYUNDAI MOTOR AMERICA
Lift the vehicle.
Remove the fuel tank.
(Refer to Fuel Delivery System - "FUEL TANK ")
Open the vapor tube and fuel feed line fixing clip (A) to using driver.

Fig 5: Opening Vapor Tube And Fuel Feed Line Fixing Clip
Courtesy of HYUNDAI MOTOR AMERICA
Remove the fuel line from the bottom of the vehicle.

Fig 6: Removing Fuel Line From Bottom Of Vehicle

Courtesy of HYUNDAI MOTOR AMERICA