LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (Fuel Delivery System - 2.0L (Except HEV)) >> Accelerator Pedal >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the accelerator position sensor connector (A).
    Fig 1: Disconnecting Accelerator Position Sensor Connector
    G11994651Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the mounting cap (A).
    Fig 2: Removing Mounting Cap
    G11994652Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the installation bolt (A), and then remove the accelerator pedal module.
Fig 3: Removing Accelerator Pedal Module
G11994653Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals