LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 23 (Engine Control System - 1.6L (Except HEV)) >> Canister Close Valve (CCV) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Lift the vehicle.
  3. Remove the rear-left wheel & tire and the wheel house cover.
  4. Disconnect the canister close valve connector (A).
  5. Disconnect the ventilation hose (B) connected to the fuel tank air filter and canister close valve.
  6. Remove the fuel tank air filter after removing the installation bolt (C).
    Fig 1: Locating Canister Close Valve Connector, Ventilation Hose And Installation Bolt
    G11987342Courtesy of HYUNDAI MOTOR AMERICA
  7. Release the lever (A), and then rotate the canister close valve (B) in the direction of an arrow.
  8. Remove the canister close valve from the fuel tank air filter.
    Fig 2: Locating Lever
    G11987343Courtesy of HYUNDAI MOTOR AMERICA
    Fig 3: Rotating Canister Close Valve
    G11987344Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals