LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Sonata Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 23 (Engine Control System - 1.6L (Except HEV)) >> Boost Pressure Sensor (BPS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the boost pressure sensor connector (A).
  3. Remove the installation bolt (B), and then remove the sensor.
    Fig 1: Locating Boost Pressure Sensor Connector And Installation Bolt
    G11987267Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals