Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.

Install the cylinder head cover.
1. The hardening sealant located on the upper area between timing chain cover and cylinder head should be removed before assembling cylinder head cover.
2. After applying sealant, it should be assembled within 5 minutes.
  Bead width : 2.0 ~ 3.0 mm (0.07 ~ 0.11 in.)
  
  Sealant : LOCTITE 5900H
  
  Fig 1: Hardening Sealant Applying Area On Upper Area Between Timing Chain Cover And Cylinder Head
  Courtesy of HYUNDAI MOTOR AMERICA
3. Install the cylinder head cover (A) with a new gasket (B).
  
  Fig 2: Locating Cylinder Head Cover And Gasket
  Courtesy of HYUNDAI MOTOR AMERICA
  
  CAUTION: Do not reuse the disassembled gasket.
4. Tighten the cylinder head cover bolts with the order and steps.
  Tightening torque
  
  1st step:
  
  3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
  
  2nd step: 7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)
  
  Fig 3: Cylinder Head Cover Bolts Tightening Sequence
  Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.